MasterWayZ
Enthusiast
Enthusiast

VMware SD-WAN Orchestrator remote diagnostics not working

Jump to solution

Hi,

Sorry if this is in the wrong forum, but I couldn't find one specifically for SD-WAN.

 

An issue I'm having in my VeloCloud lab, is that whenever I log into the Orchestrator and try to access the remote diagnostics of an Edge, it spins twice to try to load and then goes back to the edge overview under the Remote Diagnostics tab.

vExpert 2020
0 Kudos
1 Solution

Accepted Solutions
MasterWayZ
Enthusiast
Enthusiast

Someone replied here, but not sure why their message is gone.

The solution was to set `network.public.address` under System Properties.

As I have a valid trusted cert on the FQDN, instead of the IP address I had to use the FQDN in that field.

vExpert 2020

View solution in original post

0 Kudos
3 Replies
HiroKakehata
Contributor
Contributor
0 Kudos
khirom
Contributor
Contributor

Hi,

I had the same problem with OS version 4.0.
OS version 3.4 was working.

Did you try to set "network.public.address" on Orchestrator ?
In my case, the cause was "network.public.address" .

https://docs.vmware.com/en/VMware-SD-WAN/4.2.0/sd-wan-orchestrator-deployment-and-monitoring-guide/G...

0 Kudos
MasterWayZ
Enthusiast
Enthusiast

Someone replied here, but not sure why their message is gone.

The solution was to set `network.public.address` under System Properties.

As I have a valid trusted cert on the FQDN, instead of the IP address I had to use the FQDN in that field.

vExpert 2020

View solution in original post

0 Kudos