Dear all,
i'm here with the storage manager who configured the replicated LUNs.
He states everything is properly configured but as long as i try to run the array discovery from the protected site we have the error : failed to discover array.
What can we do in this case ? are there any logs were we can go through ?
Many thx in advance
Daniele
Dear all,
i solved setting the ALIAS name in capital letter :smileygrin: and the paring went fine.
Now anothe question : even if configuration went ok i still see the ARRAY Managers still not configured.
Is that ok ? when i try to edit , all is visible instead.
Many thx
Do you have volumes/luns already enabled for replication & formatted with VMFS - with at least one VM on it?
Regards
Mike Laverick
RTFM Education
Author of the SRM Book:http://www.rtfm-ed.co.uk/2010/03/22/new-administrating-vmware-site-recovery-manager-4-0/
Free PDF or at-cost Hard Copy
Hi at the moment,i have just configured the array managers in srm.
I did not configured any vmfs:shall i do it for each host connected to that lun?i need to know further steps.
Many thx
Danielef,
You need to have VMFS volumes presented to you ESX hosts.
The steps i would follow are:
create vmfs volumes and present them to ESX cluster
Place at least one VM on each vmfs volume
setup replication for teh applicable vmfs volumes
Run back through the array configuration manager
At the end of the configuration you should see the LUNs that are being replicated and that have vms on them
Hope this helps
DC