what about a short summary of your problem ?
___________________________________
VMX-parameters- VMware-liveCD - VM-Sickbay
Using convert 4.0.1 on a windows Vista x64 machine.
It errors out at about 98% with an InternalError.
Not sure how to find the important information in the logs, so I attached them to the initial post.
And ideas would be helpful...
at 98% the imaging part of the job should be done - can you check if the VM was created successfully ?
If yes - just reconfigure it again - sometimes this helps
___________________________________
VMX-parameters- VMware-liveCD - VM-Sickbay
It is there, but won't start properly.
How do I re-configure it exactly?
I think I see how to do a re-configure. It says that reconfiguration is not support for the selected source. It does correctly show it as Vista 64-bit
How do I re-configure it exactly?
? - just launch Converter and click "configure machine"
___________________________________
VMX-parameters- VMware-liveCD - VM-Sickbay
reconfiguration is not supported for the selected source
and what did you select ?
___________________________________
VMX-parameters- VMware-liveCD - VM-Sickbay
I seleced the newly created VM that was on my server.
One thing I just noticed, is that the VM is only 11G even though the source machine has 86G of used space.
I have the same whem problem with reconfiguration of Fedora VM
under Windows. Guest OS is properly working and I use it
without any problems. Does the problem depend on image
or Converter app?