vSphere vNetwork

Hi

I have configured network load balancing with 2 interfaces in vSphere Client.

On managed HP ProCurve switch I have configured the following:

HP_Core(config)# trunk A21,A22 Trk1

for these interfaces connected to ESXi 5.5.

Are these settings correct?

Try "trunk A21,A22 trk1 Trunk" and then make sure your VLANs are configured as tagged / unstaffed on trk1 as appropriate. Tagged if you are sending more than one.

i Think you can check with show trunk.

This article explains in detail how to configure port channels on the ESXi and the HP switch side:

VMware KB: Sample configuration of EtherChannel / Link Aggregation Control Protocol (LACP) with ESXi/ESX and Cisco/H…

This article explains in detail how to configure port channels on the ESXi and the HP switch side:

VMware KB: Sample configuration of EtherChannel / Link Aggregation Control Protocol (LACP) with ESXi/ESX and Cisco/H…

Thx, but is it possible to configure static port channel on 3 physical interfaces from ESXi Server? 

Thx, but is it possible to configure static port channel on 3 physical interfaces from ESXi Server?

Yes, you can have 3 or more physical NICs in a channel.