VMware Cloud Community
Matt12
Contributor
Contributor
‎08-23-2023 02:59 AM

VLAN backed segment to T1 gateway

Hello,

I am trying to connect a customer t1 gateway to an mpls link going to his office.

To achieve this, i tried to add a service interface to the customer T1 gateway. This service interface is connected to a vlan backed segment connected to the customer office.

From my org VDC, i can ping the service interface IP of the T1 gateway but I cannot go further. I cannot reach the other end (customer office). I deployed a router sitting on the vlan backed segment but this router cannot ping the T1 gateway either. It is like the service interface is not really connected to the vlan backed segment because there is no communication between the T1 gateway and the rest of the segment.

Any idea?

0 Kudos
4 Replies
scott28tt
VMware Employee
VMware Employee
‎08-23-2023 04:24 AM

Which VMware product does this relate to?

-------------------------------------------------------------------------------------------------------------------------------------------------------------

Although I am a VMware employee I contribute to VMware Communities voluntarily (ie. not in any official capacity)
VMware Training & Certification blog
0 Kudos
Matt12
Contributor
Contributor
‎08-23-2023 04:28 AM

NSX-T 3.2 & VCD 10.3

0 Kudos
Sreec
VMware Employee
VMware Employee
‎08-24-2023 02:23 AM

Most likely you are missing static routes on T1. Please note that this design is supported with 10.4.1 version 

 

Cheers,
Sree | VCIX-5X| VCAP-5X| VExpert 7x|Cisco Certified Specialist
Please KUDO helpful posts and mark the thread as solved if answered
0 Kudos
Matt12
Contributor
Contributor
‎08-24-2023 02:45 AM

It is a connected subnet on the T1, so not sure why i would need static route?

Design is supported for 10.4.1 from tenant side but we should be able to do the config from the NSX manager no matter the VCD version?

0 Kudos