So I have been trying to get vCenter working correctly as an endpoint in vRA. I have tried a number of things and when opening orchestrator and trying to fallow the workflows I found that I now had two variation of the same vCenter server instance. I removed them both thinking I would just readd the one again to see if that fixed my issue with my endpoint, but now when I try to add an instance through the workflow in orchestrator if fails and says: Connection validation failed exception There is problem with the specified PBM service at URL:https://... Error message: Unexpected status code:503. Basically my endpoint is not pulling any information from vCenter. What is the proper order of workflow I need to run to setup a vCenter endpoint. I think this might help in finding where I am failing?
Hi
Correct steps are documented in below doc to add VCenter and endpoint in VRA :
For you to add a VCenter into VRO follow below blog :
http://www.virtubytes.com/2017/09/05/connect-vcenter-vrealize-orchestrator/
Here you will first add Vcenter instance using add Vcenter instance workflow
Then run a register workflow
Please consider marking this answer as "correct" or "helpful" if you think your questions have been answered.
regards
Gayathri
Hi
Correct steps are documented in below doc to add VCenter and endpoint in VRA :
For you to add a VCenter into VRO follow below blog :
http://www.virtubytes.com/2017/09/05/connect-vcenter-vrealize-orchestrator/
Here you will first add Vcenter instance using add Vcenter instance workflow
Then run a register workflow
Please consider marking this answer as "correct" or "helpful" if you think your questions have been answered.
regards
Gayathri