I am using ESX server 3.0 . I am getting some problems in emulex driver installation. I installed an Emulex card on HP Prolient system and when I invoked lspci I got following information
06:02.0 Fibre Channel: EMulex Corporation LP952 Fibre Channel Adapter (rev 01)
As emulex driver comes by default with ESX 3.0 so I tried to check /proc/scsii but there was no entry for emulex .
Then I downloaded lpfcutil-7.3.2.tgz from following link.
After installing this driver also I couldnt get an entry in /proc/scsi.
Can anyone help me out.
Could be a possibility but I doesn't seem obvious. I just got up to something you can check.
Can you check the BIOS of the system, some Proliant's require you to set an OS Selection. The differences between setting it to Linux rather than Windows has something to do with the PCI bus, maybe something is going wrong there?
Last thing I got from another friend, within Emulex BIOS you need to set "Point to Point" can you verify that as well?
I have not had any problems using Emulex cards on VI3. When you ran "lspci" it indicates that the it sees you card on the bus.
When you installed lpfcutil, it did not install a driver. This is a package that contains diagnostic utilities.
When you look in /proc/scsi the entry would be called "lpfc"
Do you see the Emulex card listed when you issue the following command "esxcfg-module -l" It should be listed as "lpfcdd_732"
If it is not listed, try enabling the Emulex module with the following command: "esxcfg-module -e lpfcdd_732"
I have Emulex and love it.
I know 3.0 suppost the LP10000 series and up cards. I'm no so sure about prior cards.
I know when I had esx 2.5.3 it didn't support the LP10000 and up cards, I had to upgrade to ESX 3.0.