7 Replies Latest reply on Jun 24, 2020 8:47 AM by rungis

    Load balancing via IP HASH without LACP

    rungis Lurker

      Hi there,

       

      I wondering if I can setup a standard vSwitch with IP Hash without LACP.

      My customer only have an Essential Plus licence, therefore I cannot setup a distributed vSwitch and LACP protocol on my physical switch.

      If I deploy a standard vSwitch with two network cards, IP Hash load balanced and on my physical switch I set the port in trunk mode but without LACP (because it's not supported on standard vSwitch), is there a realy load balanced traffic between my two NIC or it's on active passif mode and thus 1 NIC is only active ?

       

      Thanks in advance for your answer

       

      Best regards