I just installed vro 8.1 and when I try to run the workflow to add a vcenter server, I instantly get a 403, ok error and it wont let me run the workflow.

[RY_User]

I just installed vro 8.1 and when I try to run the workflow to add a vcenter server,  I instantly get a 403, ok error and it wont let me run the workflow.

This message is seen at the top:

Http failure response for https://<vroname.mydomain.com>/vco-controlcenter/client/api/platform/workflows/f246b7b5-fe89-4da5-a6... 403 OK

This is replacing a 7.6 vro that worked just fine.

Any ideas???

I also see this when I try again:

Some data cannot be retrieved. If the problem persists, contact your system administrator.;

[6][pass.required][com.vmware.o11n.forms/evalOGNL] 403 OK

[7][user.required][com.vmware.o11n.forms/evalOGNL] 403 OK

[8][pass.visible][com.vmware.o11n.forms/evalOGNL] 403 OK

[9][user.visible][com.vmware.o11n.forms/evalOGNL] 403 OK

Message was edited by: Robert Yetter

[inevp]

I think this could happen if you recently changed your authentication provider. What is your setup - embedded or standalone vRO? What authentication provider do you use? Did you change it right before attempting to run the workflow?

[Jeremy313]

It happend to me after deployment.
What I did was clear the browser's cache and switched from Chrome to Firefox.

Hope this helps 😉