1 Reply Latest reply on Feb 20, 2020 5:27 AM by AlessandroRomeo68

    VM traffic / Management / vMotion / iSCSI on same phsyical NICs

    ghb1968 Lurker

      Hi,

       

      normal you have own NICs for ISCSI, Mgmt and also for VM traffic... To simplefy the cabling and reduce also the number of needed switches (bigger setup) Is it possible to have only 1 NIC card (e.g. 10G or 25G) with 2 ports.

       

      Example Standard configuration:

       

      NIC0 (vmnic0) & NIC1 (vmnic1) -  1G - (Active/Active or Active/Stdby)

           Management - vlan 1000  (10.10.10.0/24) - vSwitch1

       

      NIC2 (vmnic2) & NIC4 (vmnic3) -  10G - (Active/Active or Active/Stdby)

      - vMotion - vlan 1100 (10.10.20.0/24) vSwitch2

      - VM traffic - vlan 1200 (10.20.10.0/24), vlan 1201 (10.20.11.0/24) vSwitch3, vSwitch3

       

       

      NIC3 (vmnic4) - 10G - iSCSI1 (Storage Controller A) - vlan 1300  (10.30.10.0/24) vSwitch 4

      NIC5 (vmnic5) - 10G - iSCSI2 (Storage Controller B)  - vlan 1301  (10.30.10.0/24) vSwitch 5

       

       

      In a bigger set need a lot of cables and switches therefore the idea to use only 2 port NIC card e.g. with 25G (I know only 1 NIC card is SPoF)

       

      If I put all the configuration on only a 2 port NIC card I have to put several IP addresses to one NIC and in the upper examples I am using teaming for NIC0/NIC1 and NIC2/NIC4 but not for the iSCSI ports (and Jumbo frames are enabled on ISCSI ports but not on the other ports).

       

      Has anyone already expirencense with such configuration to put all traffic on only 2 NIC ports (and each traffic type is configured on the 2 ports?

      Means Mgmt is running on NIC0 and NIC1 also vMotion, VM traffic and iSCSI