3 Replies Latest reply on Jan 21, 2020 12:43 AM by kelvindp

    How to setup DMZ on vSphere Infrastructure

    kelvindp Novice

      Hi,

       

      My client have DMZ network on HyperV. And wants to migrate their VMs on vSphere 6.7. But we unable to ping the DMZ network on HyperV. I thought we missed out some requirements or other configurations.

       

      We have 4 ESXi hosts, used vmnic2 and vmnic3 (both 1G), we assign these vmnics on vSwitch1 (VSS) and create port group named as DMZ Network with an VLAN ID of 50. vSwitch1 is in Route based originating virtual port, NIC teaming on vmnic 2 and vmnic 3 are both active.

       

      I emailed their Network Administrator if he did the following steps below that I saw in this KB. VMware Knowledge Base

       

      This sample is a supported Cisco Trunk Port configuration:

      interface GigabitEthernet1/2
      switchport (Set to layer 2 switching)
      switchport trunk encapsulation dot1q (ESXi/ESX only supports dot1q, not ISL)
      switchport trunk allowed vlan 10-100 (Allowed VLAN to ESXi/ESX. Ensure ESXi/ESX VLANs are allowed)
      switchport mode trunk (Set to Trunk Mode)
      switchport nonegotiate (DTP is not supported)
      no ip address
      no cdp enable (ESXi/ESX 3.5 or higher supports CDP)
      spanning-tree portfast trunk (Allows the port to start forwarding packets immediately on linkup)

       

      Note: For more information on configuring your physical network switch, contact your switch vendor.