5 Replies Latest reply on Sep 20, 2019 1:11 AM by seamusobr1

    Skyline Update

    seamusobr1 Novice

      I had a skyline update last night to 2.0.0.2

      This morning I had to change the root password as I mislaid it

      So did the usual of doing f10 at the splash screen and adding the usual line on the boot configuration

      I then did f10 to continue boot and ran passwd to reset the password

       

      I then rebooted the appliance and it lost its gateway setting on eth0

      I then ran /opt/vmware/share/vami/vami_config_net to forcibly add the gateway back which worked and rebooted the appliance and everything works fine except when you run networkctl you get the output below which is configuring and it never goes away. Has anybody seen this

       

       

      This does not seem to go away even after the appliance has been up for an hour or more