This content has been marked as final.
Show 3 replies
-
1. Re: NSX on VLAN "0"
lhoffer Dec 3, 2018 6:28 AM (in response to MRoushdy)1 person found this helpfulYes, you can just set the VLAN to "0" when configuring VXLAN during host preparation, which will result in VXLAN traffic being un-tagged.
-
2. Re: NSX on VLAN "0"
spirest Dec 16, 2018 12:37 PM (in response to MRoushdy)Yes, but you need to verify your unmanaged switch supports 1600+ MTU or jumbo frames.
It's unlikely your unmanaged switch will run anything higher than 1500 MTU, so you'll need to verify.
-
3. Re: NSX on VLAN "0"
MRoushdy Dec 16, 2018 11:06 PM (in response to spirest)Most probably it won't support 1500+
I'm not intending to do so, I just wondered. Thanks,