When using the ping utility on Windows look at the last two lines of the ping output to get the RTT summary. It says something like
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 3ms, Average = 2ms
For a single ping the RTT is just shown as "time". In your example it's always "time<1ms", so the RTT is less than 1 millisecond.
When using the ping utility on Linux you usually get more detailed/accurate values.
RTT is the cumulative time taken to send a signal and receive an acknowledgment for the same. A simple ping test will give you the RTT between the source and the target. Is there anything in specific you want to know about RTT?
Please consider marking this answer as "correct" or "helpful" if you think your questions have been answered.
Cheers,
Supreet
Hello,
RTT: round-trip time (Latency time).
It is a latency time between source and remote devices.
From VMware it is a requirements from long distance vMotion as per the following: VMware Knowledge Base
Please consider marking this answer "CORRECT" or "Helpful" if you think your question have been answered correctly.
Cheers,
VCIX6-NV|VCP-NV|VCP-DC|
Which value is RRT?
I know, But, I don't know:
How to check it?
When using the ping utility on Windows look at the last two lines of the ping output to get the RTT summary. It says something like
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 3ms, Average = 2ms
For a single ping the RTT is just shown as "time". In your example it's always "time<1ms", so the RTT is less than 1 millisecond.
When using the ping utility on Linux you usually get more detailed/accurate values.
RTT is typically measured using a ping to calculates the time taken to reach a user device.
Actual RTT may be higher than that measured by the ping due to server throttling and network congestion.
Per example in your screenshot the RTT is less than 1 ms. (time<1ms)
Please consider marking this answer "CORRECT" or "Helpful" if you think your question have been answered correctly.
Cheers,
VCIX6-NV|VCP-NV|VCP-DC|
The last two lines of the ping output will show you the RTT.
Cheers,
Supreet
I see. Thanks !
I see, Thanks!
I see, Thanks!