Hello,
when I launch a vmcreation test on vsan, every time the timeout is reached the vm is not removed is that expected?
because we have to remove vms manually after that
regards
Hello dansoar66
Do you get the same outcome when running the Proactive VM Creation Test via the Web Client?
Cluster > Monitor > vSAN > Proactive Tests > VM creation test > Press the green button
I would imagine it uses the same functions and thus *should* clean up after itself when complete (assuming it does use the same).
Does this only occur sometimes or every time you run this?
If the former then have you tried increasing the timeout value?(default timeout is 120 seconds)
e.g.:
> Test-VsanVMCreation -Cluster $cluster -TimeoutSeconds 300
Bob
the test in the web client does not allow to set the timeout so I can not have a failed
it happends every time the test is failed
you can try by setting the timeout to 2 secs