VMware Cloud Community
BastiaanvanH
Contributor
Contributor
Jump to solution

vCloud with NSX - default gateway thru tunnel possible?

Hello,

I'm unable to find information regarding the IPSEC functionality of vCloud/NSX. We would like to pass all traffic (default gateway) thru an IPSEC tunnel, is this possible with vCloud 8.10 and NSX 6.2.7 ?

Can this be done thru vCloud GUI or does it need configuration thru NSX edge GW config?

Kind regards,

Bastiaan

Reply
0 Kudos
1 Solution

Accepted Solutions
mavelite
Enthusiast
Enthusiast
Jump to solution

Going to make some assumptions here so bear with me.

  • You're trying to setup either new Organizations or OrgvDC's
  • You want to have all inbound/outbound traffic for these OrgvDC's routed through an IPsec VPN
  • You want to use vCloud to deploy the edge itself and then setup the VPN

Assuming those above 3 statements are correct then yes you can do this. This can be done via either the GUI or via the API/PowerCLI module for vCloud. If you need some more guidance hit me up.

View solution in original post

Reply
0 Kudos
3 Replies
mavelite
Enthusiast
Enthusiast
Jump to solution

Going to make some assumptions here so bear with me.

  • You're trying to setup either new Organizations or OrgvDC's
  • You want to have all inbound/outbound traffic for these OrgvDC's routed through an IPsec VPN
  • You want to use vCloud to deploy the edge itself and then setup the VPN

Assuming those above 3 statements are correct then yes you can do this. This can be done via either the GUI or via the API/PowerCLI module for vCloud. If you need some more guidance hit me up.

Reply
0 Kudos
BastiaanvanH
Contributor
Contributor
Jump to solution

Hello, yes, all points are correct.

What steps do I need to go thru?

Thanks.

Reply
0 Kudos
BastiaanvanH
Contributor
Contributor
Jump to solution

I got it already. NSX Edge GW is policy baes IPSEC VPN. So when adding the remote network 0.0.0.0/0 it automaticly created a routing entry for it.

Thanks for the help.

Reply
0 Kudos