VMware Horizon Community
josefdi
Contributor
Contributor
‎05-23-2017 06:54 PM

Access Point 2.8 - Unable to login to admin page after reboot

I am encountering a strange issue.. Whenever i reboot the access point 2.8 , i am not able to login to the admin page..The admin page doesnt connect.

So if i delete the VM and then re deploy using the powershell script, i am able to login to the admin page, but if i reboot the AP i am unable to see admin page.. Any ideas? 

Thanks.

0 Kudos
2 Replies
dmuligan
Enthusiast
Enthusiast
‎05-30-2017 04:06 AM

Is it the port 9443 listening ?

netstat -ano | grep 9443

Is there any network route ?

0 Kudos
markbenson
VMware Employee
VMware Employee
‎05-30-2017 07:13 AM

Is this using more than 1 NIC? If so, it could be related to ambiguity in the defaultGateway setting (from the Network Protocol Profiles (NPP) gateway setting if there is more than 1).

You can check this by running the "route" command after deployment, and then again after rebotting to see if there is a difference. If this is the case, make sure only one of the NPPs has a gateway. Alternatively use UAG 3.0 and specify defaultGateway in the .ini file.

0 Kudos