VMware Communities
strme
Contributor
Contributor

vmware fusion 6 and rhinoceros 5 problem

biiig problem in rhinoceros..  on this pic you can see lot of lines..  they are there if i turning and moving object..  what can i do?  

in fusion 4 was all good..

Reply
0 Kudos
4 Replies
changhai
VMware Employee
VMware Employee

strme,

Welcome to VMware Fusion community. I have a few questions for you.

Q1: What guest OS you used?

Q2: Did you upgrade VMware Tools after you upgrade to Fusion6?

Q3: Did you enable "Accelerate 3D Graphics"?

By the way I am not familiar with this software rhinoceros; and please describe the steps and expected/actual result when you meet this issue.

Best Regards,

changhai

Reply
0 Kudos
strme
Contributor
Contributor

hei,

1  windows 7

2  yes

3  yes

i dont know how to explain better. is it quit simple..you just start rhino - open file - and here we go. i try restarting but...i have this problem from beginnig of using fusion 6 or now 6.0.1.  in rhinoceros 4 is no problem ..but new rhinoceros5 looks like are in conflict with something..  i never seen this before.

we use rhinoceros5  with fusion 4..and it was perfect..  no issues.

i gonna try to switch on off the accelerator

thanks for answer

Reply
0 Kudos
changhai
VMware Employee
VMware Employee


strme,

>>>i dont know how to explain better. is it quit simple..you just start rhino - open file - and here we go.

I download a trial RHinoceros 5, but I did not know which file should I open. please let me know how do I see the line when turning and moving object.

Best Regards,

changhai

Reply
0 Kudos
strme
Contributor
Contributor

SOrry for late answer.

do you see some lagging ? Because i try to open new file. Blank one. Just go file - new.  And axis doing the same. axis the lines getting triangel solid surfaces If i moving with space. I will try to download again and install it.  I let you know where i am. Thanks for your time. I have beer for you.

Reply
0 Kudos