1 Reply Latest reply on Jun 19, 2013 9:57 AM by muddin

    [Complete Guide] How to Increase space on Linux vmware

    kilavan Lurker

      The steps below is taken from : Extending partitions on Linux VMware virtual machines | TechRepublic . To view the pictures mentioned in the step, please go to the site, i have modified the step from that site, as some steps were not clearly explained and missing:

       

       

      1. Shutdown the VM
      2. Right click the VM and select Edit Settings
      3. Select the hard disk you would like to extend
      4. On the right side, make the provisioned size as large as you need it
      5. Click OK
      6. Power on the VM
      7. Connect to the command line of the Linux VM via the console or putty session
      8. Log in as root
      9. The fdisk command provides disk partitioning functions and using it with the -l switch lists information about your disk partitions.  At the command prompt type fdisk -l
      10. The response should say something like Disk /dev/sda : xxGB. (See Figure A)
      11. At the command prompt type fdisk /dev/sda. (if dev/sda is what was returned after step 10 as shown in Figure A)
      12. Type p to print the partition table and press Enter (also shown in Figure A)
      13. Type n to add a new partition
      14. Type p again to make it a primary partition
      15. Type: 3 (partition number)
      16. Type: t (type)
      17. Type the default numbers you see on the line. in other words select default first available cylinder to the default last cylinder. In Figure A the default last is 2610 so you type 2611 in that case.
      18. Type 3 (partition Number)
      19. Type: 8e (set type to LVM)
      20. Type w to save these changes
      21. reboot
      22. Log back in as root
      23. At the command prompt type fdisk -l. You’ll notice another partition is present.  In Figure B it is listed as sdaX.
      24. Type: pvcreate /dev/sdaX (where X i the number you see on step 23. to initialize this new partition as a physical volume s
      25. Now you’ll add the physical volume to the existing volume group using the vgextend command. First type df -h to find the name of the volume group.  In Figure C, the name of the volume group is vg_root (for me it was: . Now type vgextend [volume group] /dev/sdaX. (ex: vgextend vg_root /dev/sda4). in my case it was something like: vgextend VolGroup00 /dev/sda3
      26. Type: lvextend -l +100%FREE /dev/VolGroup00/LogVol00 to Extend the logical volume
      27. Type: resize2fs -p /dev/mapper/VolGroup00-LogVol00 to expand the ext3 file system in the logical volume
      28. You can now run the df command to verify that you have more space–df -h

      Thats all

       

      Ref:

      VMware and LVM – Increasing disk space within a Linux-based virtual machine | Jared Evans Global Microbrand

      http://www.techrepublic.com/blog/smbit/extending-partitions-on-linux-vmware-virtual-machines/286