Hiya,
I am setting up Port Binding on an ESXI host and have 2 VMkernels connected to 2 NICs, which is the correct way, but when specifying the IP address for the Target do I specify the same Group IP address for each VMkernel?
I am connecting up to a single Equalogic member.
cheers Mike
Hi,
Assign both VMkernel ports to iSCSI software adapter, then add your EqualLogic Group IP to the Dynamic Discovery tab.
i had this same question a while back so did a post on it - https://samperrin.com/vmware/equallogic-ps4100-esxi-5-5-vmkernel-setup/
Hi, if you have one target then you will add the same IP target for both iSCSI adapter.
Make sure the both vmkernels are on the same subnet.
There is a guide on how to configure this here: Configuring iSCSI Connectivity with VMware vSphere 6 and Dell PS Series Storage - Dell TechCenter Me...