Just wanted to get quick clarification from folks with setting up an EMC Clarrion array. The array has two storage processors, each processor has two 1GB interfaces. Should the config look like:
SPA1 - SUBNET1
SPA2 - SUBNET2
SPB1 - SUBNET1
SPB2 - SUBNET2
or
SPA1 - SUBNET1
SPA2 - SUBNET1
SPB1 - SUBNET2
SPB2 - SUBNET2
Trying to understand which of the two is accurate?
It´s a while ago now I setup a Clarrion with iSCSI, but I´m pretty sure it was:
SPA1 - SUBNET1
SPA2 - SUBNET2
SPB1 - SUBNET1
SPB2 - SUBNET2
If I remember correct there have been also a good documentation in the manuals, which have been shipped with the Clarrion.
Regards,
Mario
It´s a while ago now I setup a Clarrion with iSCSI, but I´m pretty sure it was:
SPA1 - SUBNET1
SPA2 - SUBNET2
SPB1 - SUBNET1
SPB2 - SUBNET2
If I remember correct there have been also a good documentation in the manuals, which have been shipped with the Clarrion.
Regards,
Mario
Thanks for the feedback, and your corret, found a great emc KB article: