Second Nic Replication Appliance

[santunez2275]

Hello Guys

In vSphere Replication 6.5.1.1832 we add second interface by isolate the traffic.

The configuration is :

eth0:

IP: 5.5.5.5

Mask: 255.255.255.0

Broadcast: 5.5.5.255

eth1

IP: 10.10.10.10

Mask: 255.255.255.192

Broadcast: 10.10.10.63

The default route in etc/sysconfig/network/routes is

default 5.5.5.1 - -

Now when show the VAMI post config, the default gateway show in the eth1 and the eth0 not show gateway in VAMI.

I changed the config in VAMI but not permit and show the error "it is not possible to make the configuration"

Now in the ifcfg-eth0 file add the gateway but post reboot the Replication not response.

Someone has had this problem, how can it be solved?

Regards

Sebastian

[NirbhayRathore]

Why do you want to add two gateway in Appliance.

You should only configure one default gateway.

For second NIC you can just add static routes as per requirement.

[JWolberg82]

I had to add a static route as well to properly route over the dedicated interface.  It works fine.

[vishy3]

I have an issue with add the static routes information to /etc/sysconfig/network/routes file

For instance to add a line to the file for example

192.168.101.0/24 192.168.101.1 dev eth1

After reboot the print route doesn't update the GW to routing table

If I add the route manually, it works fine

route add -net 192.168.101.0/24 gw 192.168.101.1 dev eth1

Is there a syntax issue??

or am I missing a step.

Replication appliance version 6.5.1-8136506