Dear Expert,
Which VMware product is for Hot Standby for double servers?
thx!
Liu Wei
Hello,
Your question is not clear. Let's know what you are exactly looking in the forum.
Hello,
Twin sisters: HPE Dl360 Gen9 servers. installed same VMs.
plan to make one Activate, and other one standby. Standby serer will take over by Failover manager.
I wonder which software could take a role to monitor working status(heart pulse detector) and give order to standby server to take work?
Brgds
Liu Wei
You need to create 'High Availability' cluster and add both physical servers under that. You need VMware vCenter server for that.
Hello,
If you using VMware infrastructure with vcenter, you can gohead with VMware Fault Tolerance. Refer the below link for FT Design & Configuration.
VMware vSphere 4 - ESX and vCenter Server
FAQ: VMware Fault Tolerance (1013428) | VMware KB
Use same processes family on both server and you will need vcenter for HA
Hello,
Two HPE DL360 gent with hdd disks.
I use vCenter server with operation management enterprise plus. One vc instance license and 6 cpu
host licenses.
using VMware builds infrastructure. HPE
virtual storage software builds one cluster
recently, no.1 Hpe DL360 defective(raid controller failure).
no.2 physical server is normal.
But all VMs hosted in no2 physical server also
breakdow.
One physical server raid controller is defective, then
all VMs will stop working. Is it normal or
some setup for HA I lost?
thx!
Liu Wei
You mean 1st host crashed due to RAID controller and VMs on 2nd host also got powered off ?
Yes.
Then this is more than RAID controller effect as your VM resides on shared storage where one host crashed, HA align other host to get control over VMs. Have you checked hardware and HA logs on 2nd host ? Check if something went wrong from storage side.
Tks for clarification for that.
due to this network is onboard vessel, which internet
link is over wireless. remote checking is difficult.(connection was often broken due to too slow internet speed)
however, remote checking result few days ago as below:
log-in no.1 esxi is ok. Esxi installed on SD. site reported Physical server health led flash slow red.
At that time, VMs hosted on No.1 show power-on Status. Actually they stop working.If click VM console icon, system gives error: does not connect to pipe.......
try to reboot no.1 physical server. Led light normal
but VMS show inaccessibly
No.2 physical server normal. But it hosted VMs also
stop working.
i used HPE SV VSA to build one cluster.
step by step as per HPE instruction. I am really hard to understand what does HPE software managed storage do?
brgds.
liu Wei
1. For 1st host as you said it had LED flashing red, this indicate some hardware issue. For this you can check Hardware logs of this server with utilities provided by hardware vendor such as IML logs for HP servers.
2. doesn't connect to pipe error is related to VMware components and configuration you have configured. You need to check for detailed error.
3. What is is the error when you say stopped working.
no.1 host. after reboot. all VMs inaccessible.
all VMs there is inactivate.
no.2 host. it said :"does not connect to pipe@......".
due to under warranty, we will request HPE to check hardware(on June, it was defective on raid controller). this is second time hardware problem.
I think the problem is over VMware.It might
be due to HPE managed storage.I wonder if one datastore defective it will cause volume LUNA breakdown? Onboard HPE Engineer explain as one datastore defective will cause whole volume stop wirking. If as this matter,
we could not accept.Better delete HPE storage management.
brgds
Liu Wei