Ephos
Contributor
Contributor

vim3 actions don't seem to be present

Jump to solution

Hi Guys,

I just deployed vCO 5.5 and was going through some initial documentation and VMware learning videos for setting up basic workflows.  I keep seeing the vim3 actions being used when action elements are added however I don't seem to have those present when I search for them in the chooser.  This is a fresh install, I wasn't sure if there was a specific library that I needed to add after the install to have these available.  I wasn't able to find anything in my searches.

Thanks

Tags (2)
0 Kudos
1 Solution

Accepted Solutions
cdecanini_
VMware Employee
VMware Employee

Make sure you have the right credentials in the plug-ins tab. Then use the "reset current plug-in version" link in the troubleshooting tab and restart the vCO service.

If my answer resolved or helped you, please mark it as Correct or Helpful to award points. Thank you! Visit http://www.vcoteam.info & http://blogs.vmware.com/orchestrator for vCenter Orchestrator tips and tutorials - @vCOTeam on Twitter

View solution in original post

0 Kudos
2 Replies
cdecanini_
VMware Employee
VMware Employee

Make sure you have the right credentials in the plug-ins tab. Then use the "reset current plug-in version" link in the troubleshooting tab and restart the vCO service.

If my answer resolved or helped you, please mark it as Correct or Helpful to award points. Thank you! Visit http://www.vcoteam.info & http://blogs.vmware.com/orchestrator for vCenter Orchestrator tips and tutorials - @vCOTeam on Twitter

View solution in original post

0 Kudos
Ephos
Contributor
Contributor

Thank you for the quick reply!  Inputting the credentials and doing the reset current plug-in version resolved the issue!

0 Kudos