Can someone verify this setup is correct, and make suggestions on improvements?
Hardware:
2x HP DL380p Gen8 Servers
1 CPU each, 10 Cores, 2.2 GHz
32 GB Ram each
8x Gbps NICs
2x HP Procurve 2920 24-port Gigabit Switches, non-stacking, setup identical
Switches are trunked together, VLANs can pass through the trunk
Ports 13-20 are set to VLAN 10 untagged, and have jumbo frames enabled for Storage Network
HP MSA 2040 SAN
4x SAS 450GB 15k rpm RAID-5 volume "production"
4x SAS 3TB 7200 rpm RAID-5 volume "storage"
iSCSI interfaces:
Controller1:
192.168.130.10
192.168.131.10
192.168.132.10
192.168.133.10
Controller2:
192.168.130.11
192.168.131.11
192.168.132.11
192.168.133.11
Software:
ESXi 5.5 Essentials Plus
Cluster with 2 Hosts, HA is enabled
Host1 Networking:
vSwitch0: VM Network & Management Network
NICs 0,4 (Active, Active) load balancing port ID - one cable going to each HP Procurve 2920 Switch
vSwitch1: iSCSI VMkernel Ports
NICs 1,2,5,6 - each iSCSI is Port Binding to a specific NIC, 9000 MTU, two cables going to each HP Procurve 2920 Switch
192.168.130.20
192.168.131.20
192.168.132.20
192.168.133.20
Host2 Networking:
vSwitch0: VM Network & Management Network
NICs 0,4 (Active, Active) load balancing port ID - one cable going to each HP Procurve 2920 Switch
vSwitch1: iSCSI VMkernel Ports
NICs 1,2,5,6 - each iSCSI is Port Binding to a specific NIC, 9000 MTU, two cables going to each HP Procurve 2920 Switch
192.168.130.21
192.168.131.21
192.168.132.21
192.168.133.21
Each datastore is set to Round Robin path selection.
