Hello,
Could any one help?
I just installed the HQ Server on windows , all went well , no error, however when I want to start the server it says service not found . Thanks :
C:\ActPerformance\HQ\server-4.6.6\bin>hq-server.bat start
wrapper | The Hyperic HQ Server service is not installed - The specified servic
e does not exist as an installed service. (0x424)
C:\ActPerformance\HQ\server-4.6.6\bin>dir
Volume in drive C is Acer
Volume Serial Number is EEBF-9059
Directory of C:\ActPerformance\HQ\server-4.6.6\bin
03/29/2014 08:36 AM <DIR> .
03/29/2014 08:36 AM <DIR> ..
03/29/2014 08:35 AM 185 db-psql.bat
03/29/2014 08:36 AM 217 db-start.bat
03/29/2014 08:36 AM 229 db-stop.bat
06/10/2012 08:30 PM 3,468 hq-server.bat
06/10/2012 08:30 PM 22,475 hq-server.sh
5 File(s) 26,574 bytes
2 Dir(s) 54,550,122,496 bytes free
C:\ActPerformance\HQ\server-4.6.6\bin>hq-server.bat start
wrapper | The Hyperic HQ Server service is not installed - The specified servic
e does not exist as an installed service. (0x424)
Press any key to continue . . .
C:\ActPerformance\HQ\server-4.6.6\bin>
as below:
run
hq-server.bat install
(to install the windows service)
and then
hq-server.bat start
Did you install the service? For Windows you need to first run hq-server.bat install to install the service, and then hq-server.bat start. Did you do that?
Ye all good ;thanks for the response I shall get into the details. Can you possibly answer one question at this point does: HQ allow to monitor appss on .NET and as well as JVM platforms in sufficient details ?Does it go into enough details to be used as replacement of Visual VM and Jconsole or profiler tools that come with JDK ?
Hope I am not diverting too much off topic, it is just I needed a quick first hand knowledge about those aspects for product evaluation. Thanks in advance. If needed I can repost this question with new heading.
Best Regards
Pronab
Hi,
It will a good idea to close this topic as Answer and open a new one.
Thanks.
how do I close it ? I have marked the original as answered!