Reply to Message

View discussion in a popup

Replying to:
Sergei13
Enthusiast
Enthusiast

View Manager configuration with Security Gateway

Hi,

I have just set a security gateway and paired it with my View Manager.

So far so good.

When I connect thru the client, I can go up to selecting the type of machine I want to use, then the client opens up wide and after a while, it shuts down saying that the connexion to the remote computer has ended !

I suspect there is something to do with the fact that I didn't change anything at all in my View Configuration / Servers / View Connection Servers parameters but since I don't have a test environment, I'd rather be cautious before doing anything stupid. :smileyconfused:

I went thru the documentation, but unfortunatelly, it is far from being obvious.

So if someone could give me a little hand Smiley Wink

I didn't checked any of the 2 boxes for Https Secure tunnel and PCoIP Secure Gateway. I guess (hope !) this is why I can't finalize the connection.

My question is what do I put in these 2 fields ?

Should I just tick them both and that's it ?

Should I tick them both plus replace what's in there with config lines from the security gateway ?

Should I configure soemthing somewhere else ?

My concerne is to activate the secure tunnelling from the manager (as I did y ignorance in the past) for my internal clients and then dropping all the connections while doing some maintenance on the View Manager !

And again, to me, the documentation is not very clear with that.

Many thanks.

Reply
0 Kudos