Reply to Message

View discussion in a popup

Replying to:
Lalegre
Virtuoso
Virtuoso

Hey @hamidja,}

First of all I recommend you to always use VST as it will be easier to administer by just configuring the Physical Switch ports in Trunk mode and allowing the required VLANs. Only use EST for an specific use case.

There is no way of assigning Uplinks individually to portgroups inside a single VDS as they are shared between all of them. What you can do is play with the Teaming and Failover policy order to get only one Uplink as active for the desired portgroups and the other one as unused.

However you are mentioning here that you have two uplinks only so following that practice will give you a single point of failure. If this is a lab then go ahead and change the policy but if not I recommend you to evaluate the recommendation mentioned above.

Reply
0 Kudos