Reply to Message

View discussion in a popup

Replying to:
jrichards
Contributor
Contributor

here's where I'm at with it now:

I created a new slip stream image using Bilou Gateux notes above. I put that ISO into UDA and it goes through the install process (using a generic non-modified template) and installs the box. When the box reboots after install, I get:

  • "Windows could not start because of a computer disk hardware configuration problem"

  • "Could not read from selected boot disk"

  • "Check boot path and disk hardware"

which points to a bad boot.ini file.

I then tried installing the system booting from the slipstream i created which appeared to work, get all the way through installing drivers, entering the key, etc. but the box gets stuck in a reboot loop when it try to come up for the first time so I'm guessing that i have to get the remaining chipset (nforce4) chipset drivers added to the slipstream which is my next task.

My question though is why do you think cd install and the UDA install using the same iso produce different results? wierd issue, i would have expected the same issue either way..

At any rate, I do feel like I'm getting closer to figuring this out. I appreciate everyone's help!!

Reply
0 Kudos