visak's Posts

I am running usage meter 3.5 and SRM 6.1.1 can some let me know what are the ports need to for communication between SRM server and usage meter server. At the movement I can't see any reports ref... See more...
I am running usage meter 3.5 and SRM 6.1.1 can some let me know what are the ports need to for communication between SRM server and usage meter server. At the movement I can't see any reports reference to SRM and getting below error message  VMware vCenter Site Recovery Manager collection failed: java.net.UnknownHostException: myservername.domain.com
For me it took between 13-16 minutes (20 VM’s) 
Please check my SRA utility screen shot and SAN advance setting configuration.Make sure remote copy consistency group fully sych before running the recovery. You can increase rate of backgro... See more...
Please check my SRA utility screen shot and SAN advance setting configuration.Make sure remote copy consistency group fully sych before running the recovery. You can increase rate of background FC copying by right clicking relevant FC volume under copy services> Flashcopy Note: - I am assuming you are not running any IBM flash copy manager  software or anything to do with  LUN re signature setting.
Our setup is SRM 5.0 with v2.1.0.121224 SRA version which works fine. I have configured the SRA utility using non pre-configured setup and configured on both sites. If the volume size are more... See more...
Our setup is SRM 5.0 with v2.1.0.121224 SRA version which works fine. I have configured the SRA utility using non pre-configured setup and configured on both sites. If the volume size are more Than 2 TB have look at the V7000 compatibility matrix for additional notes. I assume you might gone through this doc . http://www03.ibm.com/support/techdocs/atsmastr.nsf/5cb5ed706d254a8186256c71006d2e0a/906fb3333c0b35b0862577b400786956/$FILE/0003%20-%20Implementing%20DR%20solutions%20with%20IBM%20Storwize%20V7000%20and%20VMware%20Site%20Recovery%20Manager.pdf Thanks -visak
In our setup recovery site volume was configured to map to esx server initial config , after configuring the consistency group I have noticedthat mapped volumes were removed from the recovery sit... See more...
In our setup recovery site volume was configured to map to esx server initial config , after configuring the consistency group I have noticedthat mapped volumes were removed from the recovery site. If you run the recovery you will notice that volume will be mapped to esx automatically. Therefore you do not need to map the recovery site volume to esx servers. Visak
HI, Is your SRM configuration still active and running with V7000 ? did you upgrade your V7000 firmware code,SRA and SRM version to current ? Regards, Visak
Hi, Is you SRM working now with v7000 without any issue .What is your SRA and SRM version you are running Thanks, Visak
Hello Guys, I am running esxi 5.0 and SRM 5.0.1 with the IBM storage box. I have issue with the LVM.EnableResingature settings. According to my understanding LVM.resignature setting needs to set... See more...
Hello Guys, I am running esxi 5.0 and SRM 5.0.1 with the IBM storage box. I have issue with the LVM.EnableResingature settings. According to my understanding LVM.resignature setting needs to set 0 .Is this setting needs to be set on both sites LIVE and DR ? In our configuration we need to set to 1 in the live site. Many Thanks Visa