jhuertaNU1996's Posts

  Awesome!  I re-created my VM following the instructions in that PDF, and all is working great so far.  I just need to test some audio config software, and some AV control software and I should be good to go. Thanks again for the link.

  Yeah, I keep trying to run the updated VMware Tools but it doesn't even begin the process.  I believe that is why I am having issues with the resolution and not allowing for me to share my Mac bridged or NAT wireless or wired network. And yes, I did install Windows 11 ARM.

As far as other software running on the Windows ARM64 client, I am using UTM rather than VMware Fusion Player (v13).  I have been running this for quite sometime and have not had any issues with Windows software running.  Most of my software is Windows-only based software that I ran on my old PC for AV control and configuration.  All of that software seems to run just as well as it did on my PC, or on my Intel Mac. I also just recently installed some software for MS Hololens, that I needed to update some Hololenses.  That actually worked better on this UTM VM than my old Intel VMware Fusion VM. The problem I seem to keep running into with VMware Player, I can't adjust display resolution and it will not connect to my network via my laptop's wireless card.  So I am sticking to using my UTM VM and not going back to VMware Fusion.

I run into the issue with the TPM and Secutrity Boot checks when running the ISO from within Windows 11, to do and upgrade to a non-Eval copy.  It doesn't even get to the keyboard layout screen.  It does the checking for updates and then runs the compatibility check. I had also already created the registry keys, but it doesn't seem to acknowledge them.  

thanks for the update Technogeezer.  I also did the registry keys, as well as creating the ISO installer with Rufus to exclude the TPM and Security Boot checks.  I still can't get the ISO installer to get past the TPM and Security Boot.

RDPetruska, yep I have tried hostname and IP address and both automatically fail.  I have even enabled all File and Printer Sharing for both inbound and outbound rules in my Firewall.  I have even turned off my Firewall via Symantec.