gcurry1234's Posts

Re: Vmnetbridge.dll fails to copy to c:\Windows\system32

by Contributor in VMware Workstation Pro Discussions
‎10-03-2011 01:58 PM
‎10-03-2011 01:58 PM
Sorry guys, I rebuilt the workstation, it was impacting my job to much. If it was just workstation not working then that was not such a big deal but all the VM products did not work. After I ... See more...
Sorry guys, I rebuilt the workstation, it was impacting my job to much. If it was just workstation not working then that was not such a big deal but all the VM products did not work. After I rebuilt everything worked just fine, thanks for everyone help. Graeme

Re: Vmnetbridge.dll fails to copy to c:\Windows\system32

by Contributor in VMware Workstation Pro Discussions
‎09-30-2011 10:48 AM
‎09-30-2011 10:48 AM
Sorry, no path box. All I get is a box trying to copy the .dll to c:\windows\system32 then another box that says file copy failed retry or cancel. I guess the good people at VM did not expect ... See more...
Sorry, no path box. All I get is a box trying to copy the .dll to c:\windows\system32 then another box that says file copy failed retry or cancel. I guess the good people at VM did not expect this error because the error message in the box stops mid sentence.

Re: Vmnetbridge.dll fails to copy to c:\Windows\system32

by Contributor in VMware Workstation Pro Discussions
‎09-30-2011 10:42 AM
‎09-30-2011 10:42 AM
Sorry for the delay in response. Log file is attached as a fun side effect i have discovered that all other VM products have stopped working on this box. VI client says vpxclient has stoppe... See more...
Sorry for the delay in response. Log file is attached as a fun side effect i have discovered that all other VM products have stopped working on this box. VI client says vpxclient has stopped working as soon as you click on the icon to launch it and Power CLI just opens then closes a few seconds later. It might be easier to just rebuild this box, since I only use to administer our vm products. thanks for your help!

Vmnetbridge.dll fails to copy to c:\Windows\system32

by Contributor in VMware Workstation Pro Discussions
‎09-29-2011 01:27 PM
‎09-29-2011 01:27 PM
Ok, so I upgraded from Workstation 7 to 8, during the install I received the message “An error occurred while copying file vmnetbridge.dll.” After installation was complete, I did not have a b... See more...
Ok, so I upgraded from Workstation 7 to 8, during the install I received the message “An error occurred while copying file vmnetbridge.dll.” After installation was complete, I did not have a bridge connection available to the VM’s. I see from other people posts that others have similar problems, however I have tried all the available fixes but nothing resolves the issue. When I run "net start vmnetbridge" from the command line is replies with service name is unknown I tried “vnetlib64 – install bridge” but it has the same error, I also tried uninstall, reinstall. I have removed Workstation reinstalled it, run setup as administrator, and logged in as administrator but receive the same error during setup. Also I tried restoring defaults inside VM Workstaion>Network Editor, but receive the same error. I even did a repair on the installation but it did not resolve the issue. Does anyone have any more suggestions for fixing this? Any help would be appreciated, thank you.