Aiti2004
Contributor
Contributor
‎12-25-2018 12:28 AM

vcloud director appliance 9.5 setup question

Hi

I have deployed vcloud director appliance 9.5, which is the first cell.  When start the VM,  I cannot access web console , I checked the vmware-vcd service was active , and find in logs:

Missing required local configuration property: vcloud.cell.ip.primary.

As I know , In prev 9.5 , vcloud cell need two ip addresses. But it cannot add addition network when it was in deploying vcloud director appliance 9.5.

Reply
jonathanw
Enthusiast
Enthusiast
‎12-26-2018 07:39 PM

When you deploy the vCD appliance you need to set the guest VM properties for the ip address (as well as gateway, netmask, dns servers etc.) I believe there is/was an issue setting the VM properties in the vSphere H5 client so you may need to use the legacy client for this.

vCD 9.5 appliance uses a single IP address by default for both the https interface and the VMRC consoleproxy service (for VM console access - by default this is on port 8443).

Reply
paluszekd
VMware Employee
VMware Employee
‎12-27-2018 05:41 AM

Also, ensure you are using the Flex vSphere client to deploy. I've seen fields cut off using H5.

Last of all, it's not possible to add a secondary NIC to the appliance on this version. This is something that is slated for a future release.

Reply
0 Kudos