- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1. Like I said, if eth0 and eth1 are enabled, eth0 stop working. only eth1 is reachable,
Is this the case from the beginning? If your appliance deployed is done successfully both the interfaces will be UP and you will be able to reach Eth0.
How are you testing the connectivity? During the testing source and destination is on a different subnet or the same subnet?
Can you take a direct console to VM and check if you can reach any other IP in the same subnet?
Can you take a direct console to VM and check if you can reach the gateway IP?
Cheers,
Sree | VCIX-5X| VCAP-5X| VExpert 6x|Cisco Certified Specialist
Please KUDO helpful posts and mark the thread as solved if answered
Sree | VCIX-5X| VCAP-5X| VExpert 6x|Cisco Certified Specialist
Please KUDO helpful posts and mark the thread as solved if answered