Hello,

I'm a bit confused about using VMWare ESXi with an HP Microserver Gen 10 Plus v2.

I have already configured the VROC RAID in the BIOS and created a RAID 10 there.
But no matter what I do, I cannot install ESXi on the RAID.

If I start the installation directly from USB, I get four individual hard disks as installation target - despite the configured RAID.

If I use HP Intelligent Provisioning with Rapid Setup, the setup suggests the RAID as the target storage, but in the end it still installs VMWare on a single disk.

Does anyone have a tip for me?