Re: Physical switches and vSAN

ScottSzcz · ‎03-31-2022

Is MLAG absolutely necessary for all flash vSAN? We are working on a virtualization project, we have quotes ready and are sure about everything except for the switching with vsan at the moment. Long story short we're doing a small deployment, 3-nodes, under 10 VMs, and the switches we have are USW-Pro-Aggregation switches from Ubiquiti. These switches do not support MLAG. Can we achieve an all flash vSAN and manage all the traffic through two switches without MLAG?

CyberNils · ‎03-31-2022

We almost never use MLAG. Better get faster NICs and switches.

Nils Kristiansen
https://cybernils.net/

View solution in original post

IRIX201110141 · ‎03-31-2022

MLAG is not a requirement. You need redundant networking gear and when you create the ISL just be sure that it have enough bandwidth and redundancy. So a LAG with 2x10 or 2x25 would be fine between your 2 switches.

When speaking of MLAG i must think about HPE(Aruba) where other Vendors have things like VLTi and so on.

Regards,
Joerg

View solution in original post

ScottSzcz · ‎03-31-2022

Thank you . I figured it was a bit overkill and wanted to make sure I wasn't going to hit a wall with requirements.