barujfarzan
Contributor
Contributor

test ether-channel (LACP) bandwidth

Jump to solution

Hello my friends!

I created ether-channel (lacp with 3 port) between dvSwitch and cisco 4503.ether-channel is up but when i'm monitoring ports on Esxi or cisco switch, all traffic pass on 1 link. where is my problem?

i attached cisco and esx configuration.

0 Kudos
1 Solution

Accepted Solutions
barujfarzan
Contributor
Contributor
Problem resolved.
Because the load balance base on total traffic on all source and destination, not from 1 source and 1 destination.
i tested with 2 source (last bit on sources was different after xor) on 1 destination. and hash algorithm was src-dst-ip and load balancing was done.
Thanks

View solution in original post

0 Kudos
1 Reply
barujfarzan
Contributor
Contributor
Problem resolved.
Because the load balance base on total traffic on all source and destination, not from 1 source and 1 destination.
i tested with 2 source (last bit on sources was different after xor) on 1 destination. and hash algorithm was src-dst-ip and load balancing was done.
Thanks

View solution in original post

0 Kudos