VMware vSphere

 View Only

  • 1.  test ether-channel (LACP) bandwidth

    Posted Apr 15, 2019 10:18 AM

    Hello my friends!

    I created ether-channel (lacp with 3 port) between dvSwitch and cisco 4503.ether-channel is up but when i'm monitoring ports on Esxi or cisco switch, all traffic pass on 1 link. where is my problem?

    i attached cisco and esx configuration.



  • 2.  RE: test ether-channel (LACP) bandwidth
    Best Answer

    Posted Apr 16, 2019 06:15 AM
    Problem resolved.
    Because the load balance base on total traffic on all source and destination, not from 1 source and 1 destination.
    i tested with 2 source (last bit on sources was different after xor) on 1 destination. and hash algorithm was src-dst-ip and load balancing was done.
    Thanks