root password

[lwsamcn01]

HI,

new installation of EXSI 6.70 on HPE DL360 G10. During installation, the root password setup does not pop up.

So that the root password was not setup. I try reinstalltion the EXSI, it still does not pop up.

I wonder how to setup the root password. Does VM build in default root password in the OS?

Brgds

Liu Wei

[IRIX201110141]

Did you use the HPE or VMware ISO? What happend of you try a different version? A lots or unknown Password can be solved by using a gparted ISO. But it tooks the same time as re-installing a unconfigured ESXi.

About versions.... 6.7 runs out of support last october. The G10 should be certified to run vSphere 7 so you should this one.

Regards,
Joerg

[Kinnison · Accepted solution]

Hi,

Maybe I'm wrong, by chance for the installation of your system you used the so-called "Intelligent Provisioning", in this case that has already been discussed on this forum (and other) the installation process sets a default password as written here: https://support.hpe.com/hpesc/public/docDisplay?docId=a00112754en_us&page=s_config-os-setting.html in particular: The default password for EXSi 6.x and 7.x is _Passw0rd_

If I'm not mistaken, consult the HCL to be sure, the DL360G10 system should be supported up to ESXi 8.0U1.

Regards,
Ferdinando

[lwsamcn01]

Thanks Ferdinando!

[Kinnison]

Hi,

Glad to have been helpful.

I honestly admit to being a bit ignorant about it, but I've never understood what is the concrete utility of installing some version of ESXi using that "Intellingent Provisioning tool", at least on small numbers.

Regards,
Ferdinando