Hello guys,
i have just finshed to configure all the requirements to have vTPM in place :
- vCenter 6.7
- vSphere 6.7
- KMS configured
When i try to add a new vTPM chip with the add device wizard i do not have the option available.
Any idea what i'm missing ?
Thanks in advance,
Daniele
Well if you think you do not have all the necessary permissions check here: Prerequisites and Required Privileges for Encryption Tasks
However, if you are part of the vCenter Administrators group you should have all of them. Also one more thing, was your KMS correctly added to vCenter?
Hey DanieleFiore201110141,
Make sure you have the next pre-requisites:
Here some resources for you to follow supposing you did not read them yet:
Is the virtual firmware of the W10 VM UEFI?
If the virtual firmware is still at BIOS, Windows 10 has a built-in tool (MBR2GPT.exe) to convert the boot disk from MBR to GPT. The tool only works if there are maximum of 3 partitions in the existing boot disk; anything more than 3 it just fails.
https://docs.microsoft.com/en-us/windows/deployment/mbr-to-gpt
I have them all in place as well, i should have mentioned that too.
Existing W10 VM
HW 15
Boot EFI
VMpowered off
I checked also in VMption i do not have the ability to encrypt the VM, just the vmotion.
COuld it be i have not the full rights ?
Well if you think you do not have all the necessary permissions check here: Prerequisites and Required Privileges for Encryption Tasks
However, if you are part of the vCenter Administrators group you should have all of them. Also one more thing, was your KMS correctly added to vCenter?
Ok i fixed it requesting more rights , that was the problem
Please expand on the solution. I have this same issue.