Hi,
our ESX 6.0 node has 2 NIC ( 1x 10GbE - 1x 1G )
We map the iSCSI Luns using 10GbE and 1G and everything is working fine an I can view my lun with both of IP address.
Set Multipath to "Fixed" to use 10GbE as preferred way.
When I try to set my preferred path to 10GbE nothing changes, ESXi keep on to set 1GbE as preferred
I try to set-up using ESX Ui and vCenter but nothing changes.
Where I get wrong?
Thanks a lot
Could you share a screen shot of your network configuration where you have these both 10 and 1 GB cards.
regards
Gayathri
Hi thanks for reply:
Here:
Name : SynetoiSCSI Disk (naa.600144f05d1f0c4d000056b4cfbb0002)
Identifier naa.600144f05d1f0c4d000056b4cfbb0002
Type disk
Location /vmfs/devices/disks/naa.600144f05d1f0c4d000056b4cfbb0002
Capacity 2.00 TB
Drive Type HDD
Hardware Acceleration Supported
Transport iSCSI
Owner NMP
Sector Format
Multipathing Policies Edit Multipathing...
Path Selection Policy Fixed (VMware) - Preferred Path (vmhba32:C0:T0:L2)
Storage Array Type Policy VMW_SATP_ALUA
Actually I have to disable the 1G path in order to go in production.
If I anable the 1G path, automatically vmware goes to Active in 1G.
1G: vmhba35
10G : vmhba32