Hi,
I think I am lost. First of all I have correctly set up vSAN. And it was working. I have installed on it some VMs everything was fine until I checked -> Hosts and Clusters -> Monitor -> Virtual San
Then Under Network it says MTU check (ping with large packet size) this is red
I searched the internet and it was saying to increase to 9000 the MTU mine was 1500.
vCenter is running on vSAN (3 hosts cluster). From vSphere Web Client I am changing the MTU from 1500 to 9000 to the first host and the vCenter was not responding. I could do nothing. Then I logged in from esxi host to the 3 hosts and increased in all of them the MTU at 9000. Then vCenter was not responding again so I tried: "fsck /dev/sda3" and then answered yes to all questions about repairs. Then I did
shell.set --enabled true
shell
cd /bin
service-control --stop --all
service-control --start --all
From console.
Eventually I was able to log on now to vSphere Web client (vcenter) with some errors hear and there. Now the MTU is to 9000 the vSAN works (hopefully) but the MTU check is still red. Why? I am using a NETGEAR ProSAFE XS708E 8-Port 10G.
Should I reinstall vCenter to avoid future problems? Because after typing fsck /dev/sda3 it finished with some errors.
Thank you,
Frank
Kind of old post. But in case someone else come up with same issue. It was a firmware issue actually. Just be sure you have latest firmware of switch
Have you checked if the switch can also support "Jumbo Packets" / MTU=9000 ?
I haven't used those netgears, but I know the Cisco's need some extra configuration in there..
So, basically, each host has a wider pipe, but does the switch in between them?
make sure each component (switch and NIC) is set to 9000, if any component is set to 1500 you will get a flag.
Hi, the MTU checks can sometimes give a false positive. Check this thread where it is discussed further: MTU Check warning
You can verify that MTU works with vmkping and disable the MTU check to get green lights.
BR
Hi,
I it seems that I had a problem with my cable I think on third host. I have put a new cable and double checked the MTU it is 9000.
Now I have something like:
--- [IP OF THIRD HOST] ping statistics ---
3 packets transmitted, 3 packets received, 0% packet loss
round-trip min/avg/max = 0.386/0.469/0.571 ms
[root@esxi-10:~] vmkping -s 8972 [IP OF SECOND HOST]
PING [IP OF SECOND HOST] ([IP OF SECOND HOST]): 8972 data bytes
8980 bytes from [IP OF SECOND HOST]: icmp_seq=0 ttl=64 time=0.449 ms
8980 bytes from [IP OF SECOND HOST]: icmp_seq=1 ttl=64 time=0.271 ms
8980 bytes from [IP OF SECOND HOST]: icmp_seq=2 ttl=64 time=0.479 ms
So it looks good right? Shall I reset it to green? It is still red.
Ping with 1000 packets to analyze the average latency.
I had the same issue and was related NIOC settings as had VSAN on a dedicated VDS with VSAN traffic set as 100 Shares with all others not in use and high latency on 9000 ping was seen. Amended share value for management to 25% on that switch and all was then ok.
Kind of old post. But in case someone else come up with same issue. It was a firmware issue actually. Just be sure you have latest firmware of switch