Rohail2004
Enthusiast
Enthusiast

Cloning process in vCenter 5.5

I have recently upgraded from vCenter 5.1 to 5.5 and noticed the cloning process is very slow.  Did anyone else notice? any suggestions?

I still have my old vCenter 5.0 and when I clone a VM there it is much faster than 5.5 vCenter.

0 Kudos
1 Reply
vNEX
Expert
Expert

Hello Rohail,

just for clear picture, you have three independent environment’s one with 5.5 vCenter and hosts and other 5.0 based and 5.1 based?

What is the combination of vCenter/hosts versions/build you using together for testing this, you can't manage 5.5 host's with 5/5.1 vCenter that's clear ...

It is clone on the same Host ore between two hosts?

Resides cloned VM on shared storage accessible to both sides source/destination? is used same physical storage for source/destination?

In some circumstances cloning using management network so it depends of it's speed.... (if it's true check speed and duplex settings on network adapters)

Verify if your storage support the hardware acceleration functionality (VAAI) with vSphere 5.5 and check state of VAAI on hosts...

Have you check your HW compliance with vSphere 5.5 on VMware HCL...? and check if your firmware is up to date ...

Regards,

Petr

_________________________________________________________________________________________ If you found this or any other answer helpful, please consider to award points. (use Correct or Helpful buttons) Regards, P.