I configured a host-only network that was using the same subnet as my loopback address, vmnet2, so my setup in vmware gui shows
vmnet0 bridged
vmnet1 host-only
vmnet8 nat
vmnet 2 host-only
But, in the vmx file it i showed
ethernet0.connectionType = "hostonly"
ethernet1.connectionType = "nat"
ethernet3.connectionType = "custom"
it think it should say
ethernet0.connectionType = "hostonly"
ethernet1.connectionType = "nat"
ethernet3.connectionType = "hostonly"
Is this a bug?
No, it is not a bug. No trouble found.
No, it is not a bug. No trouble found.