Workstation 8 - 2 subnets in domain

[mcsewillnotbeat]

Hey,

Excuse my potential ignorance on this but I cannot figure this out:

Ok, I have a test AD environment setup in workstation 8 and I am at the point where I want to create 2 or more subnets, my current subnet over NAT is 192.168.227.x. I want 192.168.228.x also. To cut a long confusing story short, do I need additional Physical Hardware or can this be achieved through network editor? I have tried adding vnics to the vms but to no avail, Im now coming to the conclusion additinal hardware is required. Could someone please advise on this!

Many Thanks

[a_p_]

You can unfortunately have only a single NAT network. However, since you need to do the routing anyway, you may want to consider implementing a virtual router (e.g. pfSense) which connects to the public network and provides internal access for the VM's through either Host-Only networks or LAN-Segments.

André