If I have a laptop with a Intel Core i7-4810MQ processor and 32GB of ram running Windows 10. What should I select for the number of processors and number of cores for my VM machine running Windows 7/64?
Hi,
Normally, sticking with the defaults is the best advice.
That would also be the case for this. If afterwards you want to change you always can, just shut down the VM and change.
Note that "just adding more CPU" because you want a faster VM can have the opposite effect as you might end up starving the host from the required resources.
--
Wil
Welcome to the Community,
it's best practice to assign resources as needed, i.e. don't overcommit only because you have a powerful host. Overcommitting might result in unnecessary overhead.
Check the guest's requirements, start low, and increase resources if needed.
André
Thank you!
While I understand the concepts of using the defaults and not over committing resources, I don't have any practical experience in selecting the appropriate number of processors and cores. Based on the processor(s) I have in my host, what would be the default number of processors and cores to select? I moved this VM machine from an older computer so I don't know if the processors and cores are the defaults for that computer or for my new one. I suspect I should use one processor and 4 cores. What would be your suggestion?
Hi,
Just keep it frugal, a good recommendation depends on what you are going to use it for.
But I would suggest just 2 cores. Quite frankly I run my desktop windows VMs all with just 1 core.
FWIW, there's not much difference in assigning 2 CPU's and 1 core or 1 CPU and 2 cores. In both cases you are assigning two virtual CPU's to the guest.
The place where it does make a difference is software licensing.
Some software licenses are per CPU, but not limited per core and in that case it can be beneficial to assign a higher core count.
--
Wil
Thank you all for your assistance. This is my first "and only" post so I am not sure how to end it. I have settled on 1 processor and 2 cores for now. It seems to be working fine.
Thanks again,
Bill
Hi,
Letting us know how it went is a great way to end the discussion, feedback is always appreciated.
--
Wil