VMware Networking Community
MrVmware9423
Expert
Expert
‎08-20-2022 12:13 AM
Jump to solution

Ping Non NSX-T wotkload

Dear Team,

 

We have a physical DB server and app/web are part of NSX-T Logical Segments, if we would like to test the connectivity between app/web to DB (vice versa) what all changes need to be done in NSX-T (T0/T1/DFW) and Physical routers/Switch/Firewall so that we will have connectivity between these servers. please assist..

MrVmware9423_0-1660979496833.png

 

0 Kudos
1 Solution

Accepted Solutions
ShahabKhan
VMware Employee
VMware Employee
‎08-24-2022 03:19 AM
Jump to solution

Hi,

Make sure you have routing properly configured. If you are using static routing then you have to configure the route on T0 & Router and if you are using a routing protocol then make sure you have redistribution done T0. By default, all traffic is permitted on dFW so unless you have configured any deny rules or have changed the default rule to deny, there should not be any issue.

View solution in original post

2 Replies
AbdulBasitKhan
Contributor
Contributor
‎08-24-2022 02:57 AM
Jump to solution

Make your router gateway of all of yours networks, ie Physical & T0 Uplink, Make sure you add default static route in T0 Uplink interface. 0.0.0.0/0 next hope will be the router IP address connected to TOR1 & TOR2

 

Thanks

ShahabKhan
VMware Employee
VMware Employee
‎08-24-2022 03:19 AM
Jump to solution

Hi,

Make sure you have routing properly configured. If you are using static routing then you have to configure the route on T0 & Router and if you are using a routing protocol then make sure you have redistribution done T0. By default, all traffic is permitted on dFW so unless you have configured any deny rules or have changed the default rule to deny, there should not be any issue.