VMware Networking Community
cvzrx
Contributor
Contributor
‎09-20-2022 03:43 AM

NSX-T VRF

I configured VRF on NSX-T with BGP but once I enable BGP on VRF and add interfaces and BGP Neighbors the status of T0 changes to (failed)

1.jpg2.jpg3.jpg4.jpg5.jpg6.jpg7.jpg8.jpg

9.jpg

10.jpg

Any suggestion please.???

 
0 Kudos
4 Replies
Sreec
VMware Employee
VMware Employee
‎09-20-2022 05:40 AM

Can you please confirm/share the Transport Zone mapping of Edge Nodes and TO&VRF Uplinks Segments? I guess there is a mismatch. 

Cheers,
Sree | VCIX-5X| VCAP-5X| VExpert 7x|Cisco Certified Specialist
Please KUDO helpful posts and mark the thread as solved if answered
0 Kudos
ShahabKhan
VMware Employee
VMware Employee
‎09-21-2022 12:41 AM

Hi,

You have to configure VRF on the router as well & assign the interfaces to the respective VRF. Currently, I see all the neighbors are in default VRF.

0 Kudos
cvzrx
Contributor
Contributor
‎09-26-2022 12:44 AM

What did you mean all the neighbors are in default VRF?

give me more clarification please.

0 Kudos
ShahabKhan
VMware Employee
VMware Employee
‎09-26-2022 12:53 AM

Hi,

Since you have configured vrf on the T0, you should put corresponding interfaces & neighbors in vrf as well on the router. By default, all the neighbors & interfaces are part of default vrf.

0 Kudos