Petersaints
Enthusiast
Enthusiast

NSX-T 3.1.1 post upgrade alarms

Jump to solution

Hello all,

After the upgrade from NSX-T 3.1.0 to 3.1.1, i have this alarms:

Petersaints_0-1618557373753.png

I did de recommended action and everything is working and i don't see any error on syslog.
I have BDF disable, but before the upgrade i had it too, and don't have any alarms.

Any suggestion?

Thanks.

Regards.

0 Kudos
1 Solution

Accepted Solutions
Petersaints
Enthusiast
Enthusiast

hi @shank89 ,

No errors on syslog.

I already solved this issue. I need to restart the dataplane service on the active edge node to force the failover to the other edge node. After that, alarms gone!

View solution in original post

0 Kudos
4 Replies
shank89
Expert
Expert

If BGP is up and everything is working, have you attempted to resolve the alarm to see if it comes back?

Shashank Mohan

VCAP-NV 2020 | VCP-DCV2019 | CCNP Specialist

https://lab2prod.com.au
0 Kudos
Petersaints
Enthusiast
Enthusiast

Hi @shank89 ,

Unfortunately i mark them as resolved but few minutes later they appear again.

0 Kudos
shank89
Expert
Expert

Did you verify there are no errors in the log specified?

Is this a lab ?

Shashank Mohan

VCAP-NV 2020 | VCP-DCV2019 | CCNP Specialist

https://lab2prod.com.au
0 Kudos
Petersaints
Enthusiast
Enthusiast

hi @shank89 ,

No errors on syslog.

I already solved this issue. I need to restart the dataplane service on the active edge node to force the failover to the other edge node. After that, alarms gone!

View solution in original post

0 Kudos