VMware Networking Community
Petersaints
Enthusiast
Enthusiast
Jump to solution

NSX-T 3.1.1 post upgrade alarms

Hello all,

After the upgrade from NSX-T 3.1.0 to 3.1.1, i have this alarms:

Petersaints_0-1618557373753.png

I did de recommended action and everything is working and i don't see any error on syslog.
I have BDF disable, but before the upgrade i had it too, and don't have any alarms.

Any suggestion?

Thanks.

Regards.

Reply
0 Kudos
1 Solution

Accepted Solutions
Petersaints
Enthusiast
Enthusiast
Jump to solution

hi @shank89 ,

No errors on syslog.

I already solved this issue. I need to restart the dataplane service on the active edge node to force the failover to the other edge node. After that, alarms gone!

View solution in original post

Reply
0 Kudos
4 Replies
shank89
Expert
Expert
Jump to solution

If BGP is up and everything is working, have you attempted to resolve the alarm to see if it comes back?

Shashank Mohan

VCIX-NV 2022 | VCP-DCV2019 | CCNP Specialist

https://lab2prod.com.au
LinkedIn https://www.linkedin.com/in/shankmohan/
Twitter @ShankMohan
Author of NSX-T Logical Routing: https://link.springer.com/book/10.1007/978-1-4842-7458-3
Reply
0 Kudos
Petersaints
Enthusiast
Enthusiast
Jump to solution

Hi @shank89 ,

Unfortunately i mark them as resolved but few minutes later they appear again.

Reply
0 Kudos
shank89
Expert
Expert
Jump to solution

Did you verify there are no errors in the log specified?

Is this a lab ?

Shashank Mohan

VCIX-NV 2022 | VCP-DCV2019 | CCNP Specialist

https://lab2prod.com.au
LinkedIn https://www.linkedin.com/in/shankmohan/
Twitter @ShankMohan
Author of NSX-T Logical Routing: https://link.springer.com/book/10.1007/978-1-4842-7458-3
Reply
0 Kudos
Petersaints
Enthusiast
Enthusiast
Jump to solution

hi @shank89 ,

No errors on syslog.

I already solved this issue. I need to restart the dataplane service on the active edge node to force the failover to the other edge node. After that, alarms gone!

Reply
0 Kudos